Training Course Agendas

All of our training courses are provided at no charge.

These course agendas are a representation of the course material presented for the specific classes. All material is subject to change depending on the specific needs of the clients at each course.

BRE 600: Webinar – Capturing CO 2 from Syngas

Upcoming Sessions

Dates Location

9/23/2025 - 9/23/2025 Online - - Europe

This webinar explores the key steps involved in capturing carbon dioxide from syngas, focusing on the technical aspects relevant to high-pressure gas streams. Syngas, produced from processes such as Steam Methane Reforming (SMR), coal/biomass gasification, or autothermal reforming, contains a substantial amount of CO 2 that must be removed to purify hydrogen or ammonia feedstocks, comply with low-carbon fuel standards, or enable CO 2 utilization and storage (CCUS).

The first part of the session will introduce the composition of syngas and the drivers for CO 2 removal. This will be followed by an in-depth discussion of available CO 2 removal technologies for high-pressure gas streams, including:

• Chemical absorption using amine solvents

• Physical solvent systems (e.g., Selexol™, Rectisol™)

• Membrane separation

• Cryogenic CO 2 separation

Process setups will be compared using simulation examples built in ProMax, showcasing typical configurations and performance trade-offs. Special attention will be given to solvent selection, pressure effects, and process integration.

Access to ProMax is not needed for this webinar, which will take approximately 2 hours. The webinar is hosted over WebEx, and information on how to connect to the session will be provided after registration. For more information about a particular BRE 600: Webinar course please Contact Training .

Prerequisites:

• None

Agenda

• Introduction to syngas composition and the need for CO₂ removal

• Overview of high-pressure CO 2 removal technologies

• Walkthrough of ProMax simulation examples

• Process optimization and configuration trade-offs